editing how could i achieve this look

[iknazi]

Hello every one hope everybody doing great
i have a small project and i wanted to achieve this colour effect



I'm using adobe premiere cs 5
i tried to play with the level and RGB curves
but i didn't get the exactly result 100%

i would love to hear suggestions and solutions from you guys ?


new edit:
i have used canon 5d mark iii
and this is a screenshot of my project

 

[moonshieldmedia]

what kind of camera did you use? did you have the same color schemes in your set design?

 

[jax_rox]

Please post a grab of what you're trying to effect.

This will make it a lot easier to give advice.

 

[knightly]

Well exposed image, watch your highlights as this process will show off any burnt out highlights…

Blacks pushed toward blue/green

Hilights pushed toward red/orange


apply a curve to the image to stretch out the mids a bit by:
- crushing the blacks, but really close to the end point…
- lifting the whites, but really close to the end point… perhaps even a little more aggressively than the blacks…
- pull up the center point slightly to raise the mids toward the lighter colors.

Shoot in a stark environment and overlight your fill side slightly… not quite 1:1 with the key, but 1:ish should do the trick. This should allow you to make smaller moves with your color corrector so you don't degrade your image as much.

 

[iknazi]

what kind of camera did you use? did you have the same color schemes in your set design?

i have used canon 5d mark iii

this is a sceenshot from my project

 

[iknazi]

Please post a grab of what you're trying to effect.

This will make it a lot easier to give advice.

yes sure and sorry for not mentioning it earlier

i used 5d mark iii

and this is a creenshot of my project

 

[moonshieldmedia]

pretty close, right off the bat I can see you didn't add any blues into the blacks

 

[iknazi]

Well exposed image, watch your highlights as this process will show off any burnt out highlights…

Blacks pushed toward blue/green

Hilights pushed toward red/orange


apply a curve to the image to stretch out the mids a bit by:
- crushing the blacks, but really close to the end point…
- lifting the whites, but really close to the end point… perhaps even a little more aggressively than the blacks…
- pull up the center point slightly to raise the mids toward the lighter colors.

Shoot in a stark environment and overlight your fill side slightly… not quite 1:1 with the key, but 1:ish should do the trick. This should allow you to make smaller moves with your color corrector so you don't degrade your image as much.

thanks a lot my friend

this is my final result

 

[iknazi]

pretty close, right off the bat I can see you didn't add any blues into the blacks

this is what i could achieve it